Results 1 to 3 of 3

Thread: Need Torque Specs for 94 VMAX 500 for the following

  1. #1
    Junior Member Mini
    Join Date
    Jan 2011
    My Sled
    94VMAX500
    Location
    Minnesota
    Posts
    11


    Default Need Torque Specs for 94 VMAX 500 for the following

    Chaincase cover bolts
    Driveshaft bearing speedo side cover bolts
    nut on the end of drive shaft that holds bearing on -speedo side
    Clutch bolt
    Lower gear bolt
    Upper gear bolt
    brake assembly bolts
    rear axel in suspension bolt on bogey wheel(where the tensioners are)

    Thanks

  2. #2
    Member Mini
    Join Date
    Feb 2007
    My Sled
    Vmax 600
    Location
    Pa
    Posts
    45


    Default

    These are right from the Yamaha manual:

    Chaincase cover bolts 7.1 ft/lbs
    Drive Sprockets 31 ft/lbs
    Says: Brake Caliper Body 47 ft/lbs
    Driveshaft bearing speedo side cover boltsóJust make sure they are tight, no torque given
    Clutch boltsóSecondary 43 ft/lbs, Primary 87ft/lbs, take back out, retighten to 43ft/lbs
    No torque for rear tensioners, you set those are tight as you need to adjust track tension. The actual back axle at the outside of the axle each side gets 54 ft/lbs.

    Personally I think you are getting a little carried away wanting exact torque specs for everything, just make sure everything is tight, if you have any doubt, check them again after a short ride.

  3. #3
    Member Mini
    Join Date
    Feb 2007
    My Sled
    Vmax 600
    Location
    Pa
    Posts
    45


    Default

    Forgot the speedometer, says speedometer gear 17ft/lbs.

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •